Texecom Premier Elite Impaq Contact-W Instruction Manual

Instruction Manual
Premier Elite Impaq Contact-W
INTRODUCTION
• For wireless connectivity, detailed programming and system set-up
instructions please refer to the compatible RICOCHET™ technology
enabled Premier Elite wireless expander instructions.
• Featuring RICOCHET™ wireless technology the Impaq Contact-W is
designed for professional security installations.
• When using the Impaq Contact-W on an Entry/Exit route, or a 24HR
door, or where chime is required, the device attributes should be left
at default "Always Awake".
• Please see the Premier Elite 8XP-W/32XP-W Installation Manual for
details of how to change the device attributes.
ASSEMBLY
For rear tamper - fix both the detector AND the rear tamper insert to
the mounting surface. Activation of rear tamper will damage product.
Rear Tamper Insert
Battery
Only replace with 3V Lithium CR123A.
Battery Safety
• Do not throw into a fire
• Do not heat
• Do not charge
• Do not short circuit
• Do not disassemble
• Replace only with same or equivalent type
• Always observe local regulations when
disposing of a battery
• Detector will transmit low battery warning
when battery needs replacing
Reed Switch
Magnet
Non-Ferrous Mounting Material
•Maximum Break = 30mm
•Minimum Make = 15mm
Ferrous Mounting Material
•Maximum Break = 15mm
•Minimum Make = 5mm
Note: Values depend on
mounting material. See Fig.1
LED
Reed Disable
Disabled
Enabled
For wiring external wired
contacts/switches
Relearn
Place jumper on Relearn pin
header and insert battery to
learn device.
Reed
Disable
MAG1 COM MAG2