Ir96: Parameters; Parameters Modification; New-Set Values Memorisation - Carel IR32M Manual

The parameters have been organised on two levels:
FIRST LEVEL: frequent parameters. They are indicated with F in the table and the password is not
necessary to gain access to them. To modify them operate as follows:
1. press the button
2. the display shows the code of the first parameter to be modified.
3. To modify the parameters see the section "parameters modification".
SECOND LEVEL: configuration parameters. They are indicated with C in the table and it is necessary to
insert the password for any modification, as indicated here below:
1. press simultaneously the buttons
2. the display shows 00;
3. press the buttons
4. confirm by pressing
5. the display shows the code of the first parameter to be modified.
To modify the parameters see the following section "parameters modification".

Parameters Modification:

To modify a parameter operate as follows:
1. press and/or
2. press the button
3. modify its value by pressing the buttons
4. press the button
visualisation;
5. repeat all operations from the point "press

New-Set Values Memorisation:

Press the button
To exit without modifying the parameters: do not press any button for at least 60 seconds ( TIME OUT exit).
Warning: if the button

IR96: PARAMETERS

for more than 5 seconds (in case of alarm, first silence the buzzer);
and
and until 22 (password) is displayed;
;
until the parameter to be modified is displayed (see the parameters table);
to visualise the value associated to the parameter;
to confirm temporarily the newly set value and to go back to the parameter code
to memorise all newly-set values and exit the procedure.
is not pressed after modifying operations, all effected modifications will be lost.
for more than 5 seconds;
and/or until you reach the requested value;
and/or " to modify other parameters values;
58 Cod. +030220151 - Rel. 2.1 - 04/09/98