Wilfa Classic Series Instruction Manual page 37

Special safety instructions for this unit
• The unit must only be filled with cold, clean water.
• Pull out the plug when the unit is not in use.
• Only use original spare parts.
• Never use the glass jug on hotplates or in a microwave oven.
• Always remove the plug from the power socket prior to cleaning.
Electrical connection
Check that the voltage where you shall use the unit is the same as that specified on the unit.
Details can be found on the label on the unit's base plate.
When using the unit for the first time
Read these instructions carefully and retain the instruction manual for future reference.
Please run cold water through the unit without using a coffee filter or coffee prior to using
the unit for the first time.
Operation
Place the Wilfa Classic on a flat surface. Plug the power cord into the socket.
Fill the water tank with cold water to the desired amount. Place a filter paper (1x4) in the
filter holder. Place the recommended amount of coffee into the filter.
We recommend that you use filter ground coffee, 60-65 g per litre of water. Experiment with
the quantities for the first few uses until you find out how much coffee you think is best.
We also recommend that you use our WILFA GRAM STÅL scale with 1 g intervals for best
results.
Place the filter holder in the bracket and twist to the left to lock into position.
Press the power switch. The start button will flash.
Press the start button, which will then light up, in order to start the percolation process.
When the percolation process is complete, the unit will switch over to the "keep hot"
position for up to 40 minutes. The start button will remain lit during this time.
The coffee should be served fresh. Turn off the start button when you have finished using the
coffee brewer.
Wilfa Classic 4