Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for elsner elektronik KNX RW
Summary of Contents for elsner elektronik KNX RW
- Page 1 Rain/Wind Sensor KNX RW Technical specifications and installation instructions Elsner Elektronik GmbH Control and Automation Engineering Herdweg 7 D – 75391 Gechingen Phone +49 (0) 70 56 / 93 97-0 info@elsner-elektronik.de Germany +49 (0) 70 56 / 93 97-20 www.elsner-elektronik.de...
-
Page 2: Technical Specifications
Current 230 V AC version: max. 20 mA, 24 V DC version max. 100 mA, residual ripple 10% Data output KNX +/- bus terminal plug Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved. -
Page 3: Installation And Commissioning
After unpacking the device, check immediately for any mechanical damages. In case of transport damage, this must immediately notified to the supplier. Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved. - Page 4 The rain/wind sensor must be mounted onto a vertical wall (or pole). Wall pole Fig. 2 The rain/wind sensor must be mounted hori- Horizontal zontally in the lateral direction. Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
-
Page 5: Mounting The Sensor
Fig. 5 An additional, optional accessory available from Elsner Elektronik is an articulated arm for flexib- le wall, pole or beam mounting of the sensor. Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved. - Page 6 Fig. 8 a+b Drill hole plan Dimensions of rear side of housing with bracket. Sub- ject to change for technical enhancement. Langloch 7,5 x 5 mm Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
- Page 7 (soldered cable connection in case of 230 V AC version, cable with plug in case of 24 V DC version). Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
- Page 8 4) Slot for KNX clamp +/- Opening for the bus cable 6) Programming pushbutton for the teach-in of the device 7) Programming LED Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
- Page 9 Fig. 12 Make sure the cover and bottom part are pro- perly snapped together! This picture is loo- king at the closed sensor from underneath. Fastening Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
-
Page 10: Notes On Mounting And Commissioning
As a precaution, the device should always be separated from power supply for maintenance works (e.g. deactivate or remove fuse). Rain/Wind Sensor KNX RW • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
Need help?
Do you have a question about the KNX RW and is the answer not in the manual?
Questions and answers