Customer Process Guidelines
5. Check that the cover holes are locked on the socket bumps on all sides.
6.3.
Removal Guidelines
Use the specific Snap-in removal tool to dismount the cover.
Figure 17.
AirPrime Snap-in Socket Removal Tool
To dismount the cover from the Snap-in socket, insert the Snap-in removal tool in the socket cavity,
and then smoothly push the tool to pull up the cover and disengage the cover holes from the socket
bumps.
Figure 18.
Snap-in Socket Removal Tool
Repeat the same operation on each side of the cover.
Do not apply excessive force that may damage the cover or the socket.
It is recommend to only use the cover for a maximum of 3 times and then replaced.
4115102
Rev 6.0
Insertion and Removal Guidelines
Cover holes
June 15, 2017
29