Stamina Viper VG1500 Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
FRONT
A
Large Ball End
B
D
F
C
E
Small Ball End
REAR
STEP 6:
Run the SMALL BALL END of the CABLE(45) through the slot at the top end of the UPRIGHT(7).
Attach the CABLE(45) to the UPRIGHT(7) at "A" with the LARGE PULLEY(44), a HEX BOLT
(M10x1.5x95mm)(70), two WASHERS(M10)(81), and a NYLOCK NUT(M10x1.5)(83).
Run the CABLE(45) through the pulley bracket on the UPRIGHT(7) at "B". Attach the CABLE(45) to the
pulley bracket with a PULLEY(43), a HEX BOLT(M10x1.5x50mm)(68), two WASHERS(M10)(81), and a
NYLOCK NUT(M10x1.5)(83).
NOTE: Do not over tighten HEX BOLTS(68, 70) as PULLEYS(43, 44) must rotate freely after HEX BOLTS
(68, 70) are tightened.
STEP 7:
Insert the UPRIGHT(7) into the LOWER UPRIGHT(6). Do not attach the bolts yet. Attach the
CABLE(45) to the pulley bracket on the LEVER ARM(8) at "C" with a PULLEY(43), a HEX BOLT
(M10x1.5x50mm)(68), two WASHERS(M10)(81), and a NYLOCK NUT(M10x1.5)(83).
Run the CABLE(45) through the UPRIGHT(7) and LOWER UPRIGHT(6). Attach the CABLE(45) to the
pulley bracket at "D" with a PULLEY(43), a HEX BOLT(M10x1.5x95mm)(70), two WASHERS(M10)(81),
and a NYLOCK NUT(M10x1.5)(83). Repeat at position "E".
Attach the CABLE(45) to the Bracket at "F" with a PULLEY(43), a HEX BOLT(M10x1.5x50mm)(68), two
WASHERS(M10)(81), and a NYLOCK NUT(M10x1.5)(83).
STEP 8:
Secure the UPRIGHT(7) to the LOWER UPRIGHT(6) with HEX BOLTS(M12x1.75x20mm)(71)
and WASHERS(M12)(80).
8