GRAUPNER G-BOOSTER 160 Manual page 54

4:AUTOSTART – General Startup Settings
CAUTION: Do not change any settings in the AUTOSTART menu unless you know
exactly what effect the respective change will have! Wrong settings can lead to serious
problems during the operation of your jet engine.
40:SPINUP/FIRE
This parameter specifies the revolution speed at which the ignition takes place during the spin-up
of the turbine.
Standard value: 2.600 rpm
41:BURNER-MAX
This parameter specifies the revolution speed at which the start burner is switched off.
Standard value: 11.000 rpm
42:STARTER-MAX
This parameter specifies the maximum revolution speed for the electric starter.
Standard value: 26.000 rpm
43:ACCE-RAMP
This parameter specifies the time for the acceleration ramp.
Standard value: 25 seconds
44:HEAT-UP
This parameter specifies the time for the combustion chamber heating phase.
Standard value: 4 seconds
45:GLOWPLUG
This parameter specifies the voltage [V] for the glow plug.
Standard value: 11.0 V
46:BATTERY
This parameter specifies the type of supply battery (battery low detection).
Ni = NiCd or NiMh, Li = lithium-ion
Standard value: Li3s (11.1 V) or Ni10 (12 V)
Only use approved turbine batteries with 11-12 V and a sufficient capacity and current, such as the
lithium-ion battery 3/2200 (part no. 7627.3PS).
47:EGT/AMBIENT
Use this parameter to adapt the temperature sensor (EGT zero point) to the current ambient
temperature
Standard value: e.g. 21 °C (70 °F)
After a reinstallation, this setting should be checked and corrected if necessary!
48:START-UP
This parameter specifies the ignition and starting method for the jet engine.
Standard value: always KEROSENE!
GRAUPNER G-BOOSTER 160 – Manual 1.91
23