DoorKing 1803 Installation & Owner's Manual page 39

3.2.12 Programming Phone Numbers WITH Area Code Reference Numbers
Program phone numbers that are referenced to an area code (long distance and 10-digit dialing calls). Make sure that the area
code(s) have already been programmed with area code reference numbers in previous section 3.2.11. Be sure you have
programmed section 3.2.8 to YES (7-digit capability) and the directory code length that you desire in section 3.2.1.
Note: If long distance or 10-digit dialing is NOT required, program the 7-digit telephone
numbers as described in section 3.2.10.
4 1
1. Press
2. Choose and enter a directory code (1, 2, 3 or 4 digits, depending on what was programmed in 3.2.1), then press
3. Enter the two-digit area code reference number (01 through 15), then press
See tables on previous page and log tables in back of this manual for area code reference numbers that have been programmed in.
4. Enter a seven-digit phone number for the chosen directory code, then press
If the number that you are entering in this step is LESS than seven-digits, enter # in the empty spaces. For example, if the
system is connected to a PBX that requires four-digit extension numbers and you want to enter extension 2217, you would
enter this number as:
5. Repeat steps 2, 3 and 4 to enter additional long distance phone numbers.
6. Press together to end this programming sequence (beeeeeep).
0
3.2.13 Deleting Individual 7-Digit Phone Number
This programming sequence is used to delete a SINGLE phone number under a known directory code using the 7-Digit Phone
Number Programming ONLY. Note: Use section 3.2.4 when using factory default 16-Digit Phone Number Programming.
0 1
1. Press
2. Enter the directory code (1, 2, 3 or 4 digits, depending on what was programmed in 3.2.1), then press
3. Enter
4. Repeat steps 2 and 3 to delete additional phone numbers.
0
5. Press together to end this programming sequence (beeeeeep).
1800-060 Issued 7-19
Version A
and enter your four-digit MASTER CODE
2 2 1 7
and enter your four-digit MASTER CODE
, then press
? ? ? ?
(beep).
then press (beep).
? ? ? ?
(beep). This CANNOT be UNDONE!
(beep).
(beep).
(beep).
(beep).
(beep).
35