Digital Equipment DEC 3000 Series Options Manual page 94

Restarting and Testing the System
Testing Drive To make sure that the drives are connected correctly, enter the
Installation show device
the latest configuration display with the display shown when
preparing the system before adding a drive. You should see
the new drive and all the drives that were present before the
addition.
If a new drive was installed, but is not in the current display, it
has not been installed properly.
Make sure that drives are set to the correct SCSI addresses.
Make sure that no error messages appear. Two question marks
in the
error messages appear, write them down.
If a drive does not display, two or more drives may have been
installed with the same SCSI address, and you will need to
change them to ensure that each drive has a unique address.
Testing Memory To make sure that the memory modules and MMBs are
Installation connected correctly, display the system configuration by using
the
the latest memory configuration with the display shown when
preparing the system before adding any memory modules. You
should see the current system memory. If the memory figure is
incorrect, one or more memory modules have not been installed
properly.
Testing To make sure that the TURBOchannel modules are connected
TURBOchannel
correctly, display the system configuration by using the
Module
config
Installation configuration display (TCINFO and DEVNAM columns) with
the display shown when preparing the system before adding a
module. You should see the new module and all the modules
that were present before the addition.
If a new module was installed, but is not in the current display,
it has not been installed properly.
7–8 Restoring the System
command as explained in Chapter 2. Compare
display indicate an error with a drive. If any
show device
command as explained in Chapter 2. Compare
show memory
command as explained in Chapter 2. Compare the latest
show