Sony DSC-RX100M7 Help Manual page 583

Help Guide
Digital Still Camera
DSC-RX100M7
TC/UB Settings
The time code (TC) and the user bit (UB) information can be recorded as data attached to movies.
MENU → (Setup) → [TC/UB Settings] → setting value you want to change.
1
Menu item details
TC/UB Disp. Setting:
Sets the display for the counter, time code, and user bit.
TC Preset:
Sets the time code.
UB Preset:
Sets the user bit.
TC Format:
Sets the recording method for the time code. (Only when [NTSC/PAL Selector] is set to NTSC.)
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
1.
MENU → (Setup) → [TC/UB Settings] → [TC Preset].
2.
Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
* When [24p] is selected, you can select the last two digits of the time code in multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
3.
Set the other digits following the same procedure as in step 2, then press in the center of the control wheel.
Note
When you tilt the monitor to shoot a self-portrait, the time code and user bit will not be displayed.
How to reset the time code
1.
MENU → (Setup) → [TC/UB Settings] → [TC Preset].
2.
Press the (Delete) button to reset the time code (00:00:00:00).
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander (sold separately).
How to set the user bit (UB Preset)
1.
MENU → (Setup) → [TC/UB Settings] → [UB Preset].
2.
Turn the control wheel and select the first two digits.
3.
Set the other digits following the same procedure as in step 2, then press in the center of the control wheel.
How to reset the user bit
583