Sony DSC-RX100M7 Help Manual page 541

Help Guide
Digital Still Camera
DSC-RX100M7
Bluetooth Rmt Ctrl
You can operate the camera using a Bluetooth remote commander RMT-P1BT (sold separately). Select MENU →
(Network) → [Bluetooth Settings] → [Bluetooth Function] → [On] in advance. Refer to the instruction manual for the
Bluetooth remote commander as well.
On the camera, select MENU →
1
If there is no Bluetooth device currently paired with the camera, the screen for pairing as described in Step 2 will
appear.
On the camera, select MENU →
2
pairing.
On the Bluetooth remote commander, perform pairing.
3
For details, refer to the instruction manual for the Bluetooth remote commander.
On the camera, select [OK] on the confirmation screen for the Bluetooth connection.
4
Pairing is complete, and you can now operate the camera from the Bluetooth remote commander. After pairing
the device once, you can connect the camera and the Bluetooth remote commander again in the future by
setting [Bluetooth Rmt Ctrl] to [On].
Menu item details
On:
Enables Bluetooth remote commander operation.
Off:
Disables Bluetooth remote commander operation.
Hint
The Bluetooth connection is only active while you are operating the camera using the Bluetooth remote commander.
If the function does not work properly, check the following notes and then try pairing again.
Confirm that the camera is not connected with other devices using the Bluetooth function.
Confirm that [Airplane Mode] for the camera is set to [Off].
Execute [Reset Network Set.] of the camera.
Note
When you initialize the camera, the pairing information is also deleted. To use the Bluetooth remote commander, perform pairing
again.
If the Bluetooth connection is unstable, remove any obstacles, such as people or metal objects from between the camera and the
paired Bluetooth remote commander.
You cannot use the function for linking location information with a smartphone while [Bluetooth Rmt Ctrl] is set to [On].
While [Bluetooth Rmt Ctrl] is set to [On], the camera will not switch to the power-saving mode. Change the setting to [Off] when
you are done using the Bluetooth remote commander.
(Network) → [Bluetooth Rmt Ctrl] → [On].
(Network) → [Bluetooth Settings] → [Pairing] to display the screen for
541