Advertisement
17. Take the small tube support and remove the backing
tape and attach it to the printer housing as shown. Ensure
that all slack / excess is pulled through this bracket so that
the tubes between the brackets are taut.
19. If the orange ink light is displayed when the printer is
turned on. Press the ink button to move the cartridges to
the removal position. The ink button may need to be
pressed up to 5 times before it is in the removal position.
21. Press the ink button and the print head will read the
chips and begin the initial head charge.
If the printer does not perform the initial head charge and
the orange ink light stays illuminated, then you will need to
repeat the chip reset function again by following the above
2 steps.
18. Plug in the mains power cable and turn on the
printer. The printer will go through its initial ink fill before
your system is ready for use.
20. Ensure that all the cartridges are firmly pushed into
place and then hold the chip reset button for 10
seconds.
Your system is now ready for use.
Advertisement
