Advertisement
5. Remove the 4 small rubber bungs. Use a tissue to
remove any ink from the rubber bungs and place
them into the small plastic bag in step 4.
** These bungs must be retained for future use **
Repeat this for each colour then fit the
7.
supplied air filters.
9. Turn on the printer and press the ink button, so the
print head moves to the cartridge removal position.
Unplug the mains lead
This allows the print head to be manually moved.
from the back of the printer.
6. Using the long needle attachment on the
10ml syringe, draw any ink out of the
centre air chamber (through the small hole).
8. Place the bulk ink feeding unit on the right
of the printer as shown and plug the printer
in to the power supply.
** NEVER PLACE THE BOTTLES HIGHER **
** THAN THE PRINT HEAD **
If the bottles are placed higher than this the ink
may siphon into the bottom of the printer.
10. Use the small screwdriver to remove the hinge
clip that is attached the print head lid. Place
screwdriver as shown and prise it to the right.
Note: Removing this clip requires significant force
Advertisement
