Maintaining - Scantool Blackbolt 220 GSHT Manual

9. MAINTAINING

That´s easier to keep machine in good condition or best performance by means of
maintaining it at any time than remedy it after it is out of order.
1.Daily Maintenance ( by operator )
· Fill the lubricant before starting machine everyday.
· If the temperature of spindle caused over-heating or strange noise, stop machine
immediately to check it for keeping accurate performance.
· Keep work area clean; switch off power source; take chip or dust away from
machine and follow instructions lubrication or coating rust proof oil before leaving.
2.Weekly Maintenance
· Clean and coat the cross leading screw with oil.
· Check to see if sliding surface and turning parts lack of lubricant If tile is
insufficient, fill it.
3. Monthly Maintenance
· Check if the fixed portion has been loose.
· Lubricate bearing worm, and worm shaft to avoid the wearing.
4.Yearly Maintenance
· Adjust table to horizontal position for maintenance of accuracy.
· Check electric cord, plug switch, at least once a year to loosening or wearing
35