Verifying The Correct Setup; Installation Checklist - Dacor Heritage HDCT304 Installation Instructions Manual

Verifying Correct Setup
WARNING
• Make sure that power to the electrical outlet is turned off at the cir-
cuit breaker panel or fuse box and that the gas is turned off at the
gas supply valve before proceeding.
• The cooktop must be properly grounded at all times when electrical
power is applied.
Before using the cooktop, read the User Manual carefully.
1. Turn off all the burner-control knobs.
2. Plug in the cooktop.
3. Turn on power to the outlet at the circuit breaker or fuse box.
4. Press-turn one burner-control knob slowly left to HIGH
FLAME. Verify that the burner igniter sparks, then turn the
knob OFF. Repeat for the other knobs.
5. Open gas valve.
6. Perform this IGNITION TEST on all burners:
a. Press-turn the control knob slowly left to HIGH FLAME. It
may take up to 4 seconds for the burner to ignite, at which
time the igniter stops. If ignition does not occur within 4
seconds, turn the knob OFF, wait for at least 5 minutes to
allow any gas to dissipate, and repeat Step 6a.
b. After ignition, continue turning the knob to reduce flame
height. Turn the knob to the simmer setting, and ensure
the low-level flame can be adjusted.
The flame should burn steadily with a sharp, blue inner
cone that varies in length with the burner size.
NOTE: If the cooktop does not function properly, follow these
troubleshooting steps:
• Verify that power and gas are supplied to the cooktop.
• Verify that the cooktop is plugged in and power is turned on at
the circuit breaker or fuse box.
• Verify that all burners are properly assembled.
• If a burner sparks after ignition, have a licensed electrician
check the outlet for correct grounding or reversed polarity.
• Repeat the IGNITION TEST (Step 6).
• If the unit still does not work, contact Dacor Customer
Assurance: 833-35-ELITE (833-353-5483). Do not try to repair
the appliance yourself. Have available the model/serial num-
bers when you call. (See the inside cover for location.)
Dacor is not financially responsible for correcting problems
caused by a faulty installation.
10
Installation Instructions
Single-Burner
Control Knob
Dual-Burner
Control Knob

Installation Checklist

WARNING
• To ensure thorough installation, the installer should complete this
checklist.
• Proper installation is the owner's responsibility.
□
Was the power outlet grounded and located as instructed
and per applicable electrical codes? (See Pg. 3.)
□
Was the gas service for the cooktop located and installed as
instructed and per applicable codes? (See Pg. 3.)
□
Was the gas-supply inlet pressure measured to ensure it is
within the maximums in these instructions? (See Pg. 3.)
□
Was the cooktop secured with the provided hold-down
brackets? (See Pg. 8.)
□
Was the cooktop connected to the gas supply as instructed
and per applicable codes?
□
Were gas-leak tests done on all burners? (See Pg. 8.
□
Were the burners and grates assembled as instructed? (See
Pg. 9.)
□
Was proper setup verified? (See Pg. 10.)
□
Has the warranty been activated online or mailed?