Download Print this page
Dacor Heritage HCT Series Planning Manual
Dacor Heritage HCT Series Planning Manual

Dacor Heritage HCT Series Planning Manual

30”, 36” wide drop-in gas cooktop

Advertisement

Quick Links

HCT305G, HCT365G
HCT Dimensions
Cooktop Overhang Dimensions
All specifications subject to change without notice.
Heritage
30", 36" Wide
®
Drop-In Gas Cooktop
www.dacor.com
Doc #: PGH-HCT.01 Revised 22 May 2018 Page 1 of 4
All tolerances: ±¹/₁₆" (±1.6 mm), unless otherwise stated.
WARNING
• Observe all governing codes and ordinances during planning/
installation. (Contact your local building department for details.)
• This appliance must be installed as instructed in this guide.
Cooktop/Chassis Dimensions
Model
A (cooktop width)
HCT305G
30" (76.2 cm)
HCT365G
36" (91.4 cm)
PLANNING
GUIDE
B (chassis width)
27 ⁵/₁₆" (69.4 cm)
33 ⁵/₁₆" (84.6 cm)
Ph. 800.793.0093

Advertisement

loading
Need help?

Need help?

Do you have a question about the Heritage HCT Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dacor Heritage HCT Series

  • Page 1 • This appliance must be installed as instructed in this guide. Cooktop/Chassis Dimensions Model A (cooktop width) B (chassis width) HCT305G 30” (76.2 cm) 27 ⁵/₁₆” (69.4 cm) HCT365G 36” (91.4 cm) 33 ⁵/₁₆” (84.6 cm) Cooktop Overhang Dimensions All specifications subject to change without notice. www.dacor.com Ph. 800.793.0093...
  • Page 2 *If the above data does not agree with the data label, use the data on the label; **the gas-supply pressure for testing the regulator setting shall be at least 1” water column (249 Pa) above the specified manifold pressure. Gas/Electrical Dimensions All specifications subject to change without notice. www.dacor.com Ph. 800.793.0093...
  • Page 3 Measured from top of cooktop grate to combustible surface. IMPORTANT: If installing cooktop with a If installing an overhead vent hood, also check hood downdraft, install only the Dacor downdraft specifications for minimum required clearances. models specified in the table below.
  • Page 4 All tolerances: ±¹/₁₆” (±1.6 mm), unless otherwise stated. Heritage 30”, 36” Wide ® PLANNING Drop-In Gas Cooktop GUIDE Cabinet and Countertop Layout, cont. Hold-Down Bracket Clearance (front) HCT Cooktop With Dacor MvRV Downdraft (side) All specifications subject to change without notice. www.dacor.com Ph. 800.793.0093...

This manual is also suitable for:

Heritage hct305gHeritage hct365g