Table of Contents
Advertisement
7
II. ASSEMBLY
Fig.2-7
(J) Dia-polarizer
Cautions when dismounting
• Remove the N D filter cassette
if attached .
• Lower the condenser carrier to
its limit by turning the
condenser focus knob.
Remove the condenser by
releasing the condenser clamp
screw.
• Fit the dia-polarizer into the bottom of the condensor (Fig. 2-8).
Fig.2-8
Fig.2-9
@ Intermediate Tube
• Mount the intermediate tube onto the microscope arm fitting the
notch of the circular devetail of the intermediate tube with the end of
the clamp screw. Tighten the clamp screw holding the mid-stem of
the hexgon wrench. Do not over tighten the screw holding the
L-shaped holder of the wrench. (Fig. 2-9)
®
1 /4A & Tint Plate
• Remove the screw from the side of the 1/4 A plate. I nsert the plate
Into the compensator slot of the intermediate tube facing the
positioning notches toward the user.
Screw in the screw once removed (Fig. 2-10).
Fig.2-10
Fig.2-11
Advertisement
Table of Contents
