Table of Contents
Advertisement
II. ASSEMBLY
Fig.2-18
Fig.2-19
@ Power Cord
e
Connect the socket of the power cord to the AC inlet on the rear of
the base (Fig. 2-19). Plug in the other end of the cord to an AC line
receptacle with the ground conductor (earth conductor).
For
100-120Varea------------------------------~
e
Use only the following power supply cord set.
U L listed, detachable cord set. 3-conductor grounding type SVT,
No. 18 AWG rated a minimum 1 25V, 7 A.
el n case of using the extension cord, use only the power supply
cord including PE wire.
For220-240Varea------------------------------~
e
Use only the 3-pole power supply cord type H05VV-F or
H05VVH2-F, which must be approved according to DIN VDE
0625. The plug and the outlet are to be approved according to
DIN VDE 0620 and DIN VDE 0625, respectively.
e
Class
I
equipment should be connected to PE (protective earth)
terminal.
eln case of using the extension cord, use only the power supply
cord including PE wire.
@
Hexagon Wrench
e
The hexagon wrench
IS
stored
in the back of the microscope
sta nd .
Take it out as shown in
Flg.2-20.
Fig.2-20
10
Advertisement
Table of Contents
