Table of Contents
Advertisement
II. ASSEMBLY
@ Binocular Eyepiece Tube
e Mount the eyepiece tube onto the intermediate tube fitting the notch
of the circular dovetail of the eyepiece tube with the end of the
clamp screw. Tighten the clamp screw using the hexagon wrench.
(See @ and Fig.2-11 .)
I
Cautions when clamping
I
eTighten the eyepiece tube clamp screw holding the stem of the
hexagonal wrench. If overtightened holding the plastic part,
optical-path change-over of the eyepiece tube may be
malfunctioned.
QJ) Eyepiece
e Use the same magnification eyepieces for both the right and left
eyes.
elnsert the eyepieces into the sleeves of the binocular eyepiece tube
by engaging the three grooves of the eyepiece with the three
protrusions of the sleeve (Fig. 2-12).
e When using eyeguard rubbers, put them onto the eyepieces
(Fig.2-13).
Fig.2-12
*Rotation clamp ring for the eyepiece
Fig.2-13
The rotation clamp ring is mounted on the eyepiece sleeve to
prevent the rotation of the eyepiece.
When removing the eyepiece, take care not to accidentally hold this
ring and pull it out together with the eyepiece.
Rotation clamp ring
for the eyepiece
Fig.2-14
8
Advertisement
Table of Contents
