Hub Blade; Table 5-3 Hub Blade Ip Addresses - Emerson AXP 1410 Installation And Use Manual

Gateway: 172.16.0.170
Submask: 255.255.0.0
*Change backplane address:
shm9s8:~ # hpiship -n 8449 -i 200.200.0.0
5.2.4.1.4 VIrtual IP Address on Out-Of-Band Interface
The virtual out-of-band interfaces are eth0:1 on both shelf manager.
5.2.4.1.5 Configuration File
By default, the shelf manager automatically reads the shelf IP connectivity record and
calculates IP addresses based on the described scheme.
It is possible to change the IP setup by editing the network.conf file. This file allows you to
configure all IP parameters without the SGA scheme and to assign IP addresses via DHCP.
5.2.4.2

Hub Blade

The external IP addresses of the hub blades are not pre-defined. They are defined by the user
and correspond to the IP address defined in U-Boot, for example, during the installation.
the internal IP addresses of the hub blades differ depending on the slot they are installed in.

Table 5-3 Hub Blade IP Addresses

Logical Slot Number
1
2
AXP 1410 Installation and Use (6806800H70F)
Interface IP Address
Base 192.168.21.1
192.168.22.1
Fabric 192.168.11.1
192.168.12.1
Base 192.168.21.2
192.168.22.2
Fabric 192.168.11.2
192.168.12.2
Configuring and Operating the System
VLAN Ethernet Interface
21 eth3.21
22 eth3.22
11 eth2.11
12 eth2.12
21 eth3.21
22 eth3.22
11 eth2.11
12 eth2.12
93