Grandstream Networks HT814 User Manual page 21

04 "Gateway " + IP address
05 "DNS Server " + IP
address
07 Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP
Address
14 Configuration Server IP
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
86 Voice Mail
99 "RESET"
"Invalid Entry"
"Device not registered"
Same as menu 02
Same as menu 02
Press "9" to move to the next selection in the list:
•
PCM U / PCM A
•
iLBC
•
G-726
•
G-723
•
G-729
•
OPUS
•
G-722
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the WAN port and
one for the LAN port. The device MAC address announced is the
address of LAN port.
Press "9" to toggle between enable/disable.
Default is disabled.
Announces current Firmware Server IP address. Enter 12-digit new
IP address.
Announces current Config Server Path IP address.
new IP address.
Upgrade protocol for firmware and configuration update. Press "9" to
toggle between TFTP / HTTP / HTTPS/ FTP/FTPS. Default is HTTPS.
Announces Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the following three
options:
•
Always check
•
Check when pre/suffix changes
•
Never upgrade
Enter the target IP address to make a direct IP call, after dial tone. (See
"Make a Direct IP Call".)
Access to your voice mails messages.
Press "9" to reboot the device.
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook If the device is
not register and the option Outgoing Call without Registration is in NO
HT812/HT814 User Guide
Version 1.0.15.4
Enter 12-digit
P a g e | 20