Devolo Magic Series Manual page 30

To do so, enter the desired new password twice.
Now the web interface is protected against un-
authorised access with your custom password!
Identify Device
The devolo Magic adapter can be located using the
Identify device function. Click Identify to make
the white LED for the corresponding adapter flash
for 2 minutes to make it easier to identify by sight.
LED
Enable the LED disabled option if the LEDs on the
devolo Magic adapter are intended to be switched
off for normal operation. An error status is indica-
ted by corresponding flashing behaviour regard-
less of this setting (see Chapter 2.3.1 Reading the
indicator light).
Powersaving
If Powersave mode has been enabled, the
1-1
devolo Magic 2 LAN switches to Powersave
mode automatically whenever reduced data trans-
mission over ethernet is detected.
The latency (time for transmitting a data
packet) may be negatively affected.
Powersave mode is
1-1
devolo Magic 2 LAN factory default settings.
Configuration 30
disabled in the
1-1
devolo Magic 2 LAN