Related Manuals for Eaton GridAdvisor II Series
Summary of Contents for Eaton GridAdvisor II Series
- Page 1 Energy Automation Solutions Effective April 2019 IL915001EN Supersedes August 2017 GridAdvisor™ Series II smart sensor installation instructions...
-
Page 2: Disclaimer Of Warranties And Limitation Of Liability
INFORMATION SHOULD NOT BE CONSIDERED AS ALL-INCLUSIVE OR COVERING ALL CONTINGENCIES. If further information is required, Eaton should be consulted. In no event will Eaton be responsible to the user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental, or consequential damage or loss whatsoever;... -
Page 3: Safety For Life
Safety for life Eaton meets or exceed all applicable industry standards relating to product safety in its products. We actively promote safe practices in the use and maintenance of our products through our service literature, instructional training programs, and the continuous efforts of all Eaton’s employees involved in product design, manufacture, marketing, and service. -
Page 4: Installation Procedures
Re-tighten cap from 17-22 in-lbs of torque to prevent any water ingress. Quality standards ISO 9001 certified quality management system GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com... - Page 5 OTASP results can be confirmed in the sensor’s communication logs with the ProView NXG software. GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com...
- Page 6 Figure 3. Incorrect methods of concentric neutral primary cable preparation ELBOW TIE-OFF ELBOW TERMINATED NEUTRAL LOCATE WIRES THE SENSOR PORTION OF THE FAULTED CIRCUIT INDICATOR (in the outlined area) NEUTRAL WIRES GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com...
- Page 7 Remove the hotstick. Note: On 200 A load-break elbows, the preferred installation is demonstrated in Figure 4 (A), where the closed core CT is located directly below the test point. GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com...
- Page 8 Three (3) red LED flashes in succession ten (10) times. Contact utility network administrator to verify proper Contact utility network administrator to verify proper configuration of cellular account. configuration of cellular account. GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com...
- Page 9 GridAdvisor Series II smart sensor and other equipment from Eaton. For technical support, contact EAS Support at 800-815-2258 or EAS-Support@Eaton.com, or contact your local Eaton representative. GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com...
-
Page 10: Regulatory Information
(2) this inspection. device must accept any interference received, including interference that may cause undesired operation. Improper battery use may result in a fire, explosion or other • hazard. GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com... - Page 11 Regulatory information GridAdvisor™ Series II smart sensor installation instructions IL915001EN April 2019 Eaton.com...
- Page 12 Eaton 1000 Eaton Boulevard Cleveland, OH 44122 United States Eaton.com Eaton’s Cooper Power Systems Division 2300 Badger Drive Waukesha, WI 53188 United States Eaton.com Electrical Automation Solutions Division 3033 Campus Drive, Suite 350N Minneapolis, MN 55441 United States Eaton.com © 2019 Eaton All Rights Reserved Eaton is a registered trademark.
Need help?
Do you have a question about the GridAdvisor II Series and is the answer not in the manual?
Questions and answers