Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Eaton EAFR-01
Summary of Contents for Eaton EAFR-01
- Page 1 MN026008EN Arc Sensor User Manual EAFR-01 EAFR-06 EAFR-08 EAFR-07...
- Page 2 CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or other- wise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to damage or...
-
Page 3: Table Of Contents
2. SENSOR CONNECTION ......... . . 4 2.1 Arc Light Point Sensor EAFR-01 Connection......4 3. - Page 4 MN026008EN Arc Sensor User Manual MN026008EN February 2016 www.eaton.com...
-
Page 5: Arc Sensors
The EAFR-01 point sensors can be installed either on or through the compartment wall. An example of on the wall mounting is seen in Figure 2. The EAFR-01 sensor is fixed against the wall using two screws. Arc Sensor User Manual MN026008EN February 2016 www.eaton.com... -
Page 6: Arc Light Fiber Optic Loop Sensor (Plastic) Eafr-06
Cable connectors are located beneath the covers on each end of the EAFR-01 sensors. The cov- ers can be conveniently detached for fastening the sensor wires. Reattach the covers after installing the wires. Cable... -
Page 7: Arc Light Fiber Optic Loop Sensor (Glass) Eafr-07
If accidental breakage of the loop sensor occurs, on site. If accidental breakage of the loop sensor occurs, Eaton recommends replacing the loop sensor. Contact your Eaton recommends replacing the loop sensor. Contact your nearest Eaton representative for more information. -
Page 8: Sensor Type Dependencies
2. Sensor Connection Figure 6. EAFR-08 Arc Light Fiber Optic Loop Sensor (High Temperature). 2.1 Arc Light Point Sensor EAFR-01 Connection Open the sensor side covers and then detach the pluggable connectors from the sensor PCB. Prepare the three twisted shielded pair cable connection (see Figure 7). - Page 9 After completing the system auto-configuration setting, Figure 11. Cable Connected to the Sensor PCB. the ERROR LED should be reset and then close both end covers of the point sensors (see Figure 14). Arc Sensor User Manual MN026008EN February 2016 www.eaton.com...
- Page 10 10. For arc light fiber sensors, they can be plugged into the back of an EAFR relay as shown in Figure 16. Arc Sensor User Manual MN026008EN February 2016 www.eaton.com...
-
Page 11: Ordering Codes
Arc light glass fiber sensor (High Temperature) - 40 m (131.23 ft) EAFR-08-45 65C2015G08 Arc light glass fiber sensor (High Temperature) - 45 m (147.64 ft) EAFR-08-50 65C2015G09 Arc light glass fiber sensor (High Temperature) - 50 m (164.05 ft) Arc Sensor User Manual MN026008EN February 2016 www.eaton.com... - Page 12 Eaton 1000 Eaton Boulevard Cleveland, OH 44122 United States Eaton.com © 2016 Eaton All Rights Reserved Eaton is a registered trademark. Printed in USA Publication No. MN026008EN / TBG1251 All trademarks are property February 2016 of their respective owners.
Need help?
Do you have a question about the EAFR-01 and is the answer not in the manual?
Questions and answers