Mains Connection; Starting Operation; Machine Operation; Setup And Adjustments - Jet JTS-600XL Operating Instructions Manual

Fig 15
Mount the Y-piece (EE) and the
connecting hose (H) for the upper dust
collection.
The flow rate on the suction port dia.
100mm must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the machine ground
system.

5.4 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine licence
plate.
The mains connection must have a
16A surge-proof fuse.
Only use connection cables marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
Attention:
-Check first if the saw spindle runs
freely and if all safety devices are
fitted before starting the machine.
For safety reasons this must only be
done without the sawblade installed!
- If the direction of rotation is not
correct, the phase converter inside the
CCE Euro plug must be pushed in and
turned 180°.
(Clockwise direction of the spindle is
correct).

5.5 Starting operation

You can start the machine with the
green On-button. The red Off-button
stops the machine.
In case of machine overload the motor
overload cut-off will react.
After appr.10 min of cooling the
machine can be started again.

6. Machine operation

Correct working position:
In front of the machine standing out of
the line of cutting (danger zone).
Fig 16
Workpiece handling:
Hands placed flat on the workpiece
outside the cutting area.
Feed the workpiece towards the saw
blade in the direction of the saw line.
Push the workpiece steadily forward;
complete the cut as a single
movement.
Support long and wide workpieces
with helping roller stands.
The use of a power feeder is not
considered.
Operating hints:
Work only with a sharp and flawless
sawblade.
Take care that the selection of the saw
blade depends on the material to be
cut.
Use a suitable wedge to prevent round
timber from turning under the pressure
of the cut.
Use suitable table extensions and
supporting aids for difficult to handle
workpieces.
Always hold and guide the workpieces
safely during machining.
Do not perform any operation
freehand.
Take care when slotting.
When ripping narrow workpieces
(<120mm) use as push-stick or push-
wood.
8
Fig 17
Make sure that small cut off
workpieces will not be caught and
thrown away by the rising saw blade
teeth.
Remove cut and jammed workpieces
only when motor is turned off and the
machine is at a complete standstill.
Pay particular attention on reducing
the risk of kickback.
The supplied raving knife must always
be used.
For the authorized use of the
machine observe the appendix A

"safe operation"

(on the last pages of this operating
manual)
A.1.: Ripping
A.2.: Ripping of narrow stock
A.3.: Crosscutting on rip fence
A.4.: Use of push wood handle

7. Setup and adjustments

General note:
Setup and adjustment work may
only be carried out after the
machine is protected against
accidental starting by pulling the
mains plug.

7.1 Changing sawblade

The sawblade has to meet the
technical specification.
Use only sawblades according to EN
847-1
The maximum diameter of the saw
blades used on the machine is 250
mm.
Check sawblade for flaws (cracks,
broken teeth, bending) before
installation. Do not use faulty
sawblades.
Warning:
The use off HSS saw blades is
prohibited; use only carbide tipped
saw blades.