Dust Connection; Mains Connection - Jet JTS-600X Operating Instructions Manual

Fig 8
Lower the sliding table end cover and
tighten screws.
Sliding Table Adjustment:
The sliding table is adjusted ex works.
The sliding table must be aligned to
run parallel to the sawblade and table
surface to be 0,1 - 0,4 mm higher than
the machine table. Use rip fence
profile to check (Fig 9).
Fig 9
Adjustment:
The sliding table guide assembly can
be adjusted up-down and parallel to
the sawblade.
Loosen the nuts (D, Fig 10) as
needed.
Grub screws (C) allow a guided
adjustment in vertical and horizontal
direction.
Fig 10
The sliding table guide rollers can be
used for micro adjustments.
A) Adjustable in height, for precise
alignment to the machine table
B) Excentric shafts, for backlash-free
movement of the roller guide.
Mounting Sawblade
See chapter 7.1
Adjusting Raving Knife
See chapter 7.2
Mounting Saw Guard
See chapter 7.3
Mounting crosscut table
See chapter 7.8
Fig 11
Mounting crosscut fence
See chapter 7.9

5.3 Dust connection

Before initial operation, the machine
must be connected to a dust extractor.
The suction should switch on
automatically when the saw is
switched on.
7
A connecting hose, a hose support, a
Y-piece and a hose tye are supplied
with the machine.
Mounting Hose Support:
Attach the hose support (AA, Fig 12)
to the table extension with the
supplied fastening clip.
Fig 12
Mount the plastic hose protection tube
(DD) into the machine stand.
Mount at a distance of approximately
250mm to the end an additional hose
tye (FF). This will protect the hose
from pulling out .
Mount the Y-piece (EE) and the
connecting hose (H) for the upper dust
collection.
The flow rate on the suction port dia.
100mm must be 20m/sec.
Flexible hoses must be of non-
flammable quality, and must be
connected to the machine ground
system.

5.4 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.