Dust Connection - Jet JTS-600XL Operating Instructions Manual

Fig 10
Fig 11
Crosscut table setup
Crosscut table setup shall never be
performed when the machine is
running.
Lift the crosscut table (R, Fig 12) onto
telescopic arm and slide onto sliding
table T-groove and lock in place).
Fig 12
Crosscut table and telescopic arm are
rough aligned ex works (The table
surface must be in level with the
sliding table).
Telescopic arm adjustment:
The telescopic arm is adjusted ex
works.
For correction, move the sliding table
so that telescopic arm reaches out
straight (like shown in Fig 12)
Align the crosscut table height with the
two hex nuts (S).
Use crosscut fence profile (U) to
check.
Move the sliding table forward.
For example: if the crosscut table falls,
tighten the left adjust screw (T, Fig 13)
until the crosscut table does not move
in height during sliding table travel.
Loosen and tighten the adjust screws
and lock nuts as needed.
Fig 13
Finish alignment by setting crosscut
table and machine table in level with
nuts (S).
Lock the two nuts (S, Fig 12) against
each other.
Start the machine with care.
Crosscut fence setup:
Crosscut fence (U, Fig 12) setup shall
never be performed when the machine
is running.
The cross-cut table has 2 precision
holes, allowing the crosscut fence to
be put in 2 positions:
At the back and front of the crosscut
table.
Simply put the fence onto the cross-
cut table and lock it in position using
the supplied knobs.
The 90° adjustable stops (R, Fig 12)
are factory set.
The fence scale is factory set.
Adjustment can be made by moving
the pivot point along the T-grove.
Confirm by test cuts.
7
When, after some time, the plastic
protection cap at the front on the
cross-cut fence is cut away, a new one
has to be installed
(part no.: JTS600-178).
Mounting Sawblade
See chapter 7.1
Adjusting Raving Knife
See chapter 7.2
Mounting Saw Guard
See chapter 7.3

5.3 Dust connection

Before initial operation, the machine
must be connected to a dust extractor.
The suction should switch on
automatically when the saw is
switched on.
A connecting hose, a hose support, a
Y-piece and a hose tye are supplied
with the machine.
Mounting Hose Support:
Attach the hose support (AA, Fig 14)
to the table extension with the
supplied fastening clip.
Fig 14