Fluke ScopeMeter 123B User Manaul page 157

YZWX
5. U se and  to enter the time in hours
and minutes.
Events are used to determine how often the
measured reading deviates from the initial reading
when recording starts. It is easy to see the time of a
deviation when you view the recording after it stops.
YZ
6. U se to highlight Set Threshold.
YZ
7. P ush  and use
percentage deviation for meter readings.
YZ
8. U se to highlight the memory type for recording
as either the internal memory of the Test Tool or an
SD memory card.
9. P ush  to accept the memory location.
10. Push 4 when done.
11. To start or stop a recording, push  or 4.
The Test Tool continuously logs all readings to memory
and displays these as graphs. When both input A and
input B are on, the upper graph is input A.
The Test Tool beeps when an event occurs. If
no event is specified, a beep happens when a
new minimum or maximum value is detected.
and  to enter the
Note
The Recorder shows a graph derived from the MAIN
readings.
The other readings show the average (AVG), the
minimum (MIN), and the maximum (MAX) reading since
the Recorder start and the time of the most recent change
of a value.
Industrial ScopeMeter®
Recorder Mode
hxv40.eps
51