Vertical Cursors - Fluke ScopeMeter 123B User Manaul

Vertical Cursors

Use vertical cursors to measure the time difference "t"
between the cursors and the voltage difference between
the two markers.
To use the cursors for a time measurement:
1. Push 3 to select CURSOR ON.
2. Push 1 to select . Observe that two vertical
cursor lines are shown on the screen. Markers (-)
identify the point where the cursors cross the
waveform.
3. P ush 2 to select the left cursor.
WX
4. U se to move the position of the left cursor on the
waveform.
5. P ush 2 to select the right cursor.
WX
6. U se to move the position of the right cursor on
the waveform.
Industrial ScopeMeter®
Scope and Meter Mode
hxv24.eps
33