Service And Connection Elements - Siemens QMX3.P37 Technical Principles

Connection
Service LED (red) and
programming pin
Adhesive address
labels
Simplifying engineering
and commissioning
8 / 46
Siemens
Building Technologies
1.4

Service and connection elements

R1 QMX3... Room operator unit
N1 Controller, actor
Twisted pair
The service element functions are described Commissioning, sections 5.2 and 6.2.
The devices are supplied with peel-off adhesive address labels containing the
unique KNX ID as alphanumeric and barcode display.
The address label can peeled off the device during mounting and stuck to a floor
plan or similar. The floor plan thus contains the assignment of KNX IDs and
physical installation location. This greatly simplifies the following steps. In addition,
the procedure serves as the basis for the recommended engineering and
commissioning process. If the adhesive labels are lost, all information is still
available in printed form on the housing.
Wall-mounted sensors and room operator units for KNX/ETS and KNX/ACS
Devices
Service LED (red)
Programming pin
CM2N1602en_05
2018-09-14