Rangemaster Elite SE User Manual page 30

Check that the oven light is working.
Note: The oven light bulb is not included in the
guarantee.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of
the cooker. Hook the central keyhole over the central
screw. Twist and fit each end keyhole over their
respective screws. Tighten the fixing screws.
Refit the drawer
Rest the drawer back on the side runners and,
keeping it level, push it right back. The clips should
click into position holding the drawer to the side
runners
To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fixing screws and use the
notch and a flat bladed screwdriver to move the
position of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
Check the appliance is electrically safe and gas sound when you have finished.
INSTALLATION
Customer care
Please complete your contact details in the front of
this section. Please inform the user how to operate
the cooker and hand over the instruction pack.
Thank you.
Conversion to LP gas
Check in the Technical Data section at the back of
the book that the cooker is convertible to the gas
you want to use.
This conversion must be performed by a competent
person. After conversion the installation must comply
with the relevant regulations and also the local
electricity supply company requirements. Read the
instructions before converting this appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead to
prosecution.
This instruction must be used in conjunction with
the rest of the appliance instruction, in particular
for information on Standards, cooker positioning,
connection hose suitability etc.
When servicing or replacing gas-carrying
components disconnect from gas before
commencing operation and check appliance is gas
sound after completion.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from the electricity supply before
commencing servicing. Before electrical re-
connection, check that the appliance is electrically
safe.
Jets
Remove burner caps and heads. Remove old jets.
Fit new jets (see the table for the correct jets).
Reassemble in reverse order.
Tap adjustment
Pull off all the control knobs.
Remove the 3 screws at the rear of the top edge of
the control panel.
Open the oven doors and remove the 2 fixing screws,
one at each end, underneath the control panel.
Pull the control panel forward and disconnect the
wiring from the rear.
Remove the shield covering the control taps
(2screws).
30