Table of Contents
Advertisement
Conversion
All models are supplied set for use on group H natural gas.
A conversion kit for LP gas is included with the appliance.
See the instructions that are supplied with the conversion
kit. After converting the appliance please attach the Gas
Conversion sticker over the appropriate area of the data
badge, this will identify the gas type the appliance is now
set for.
This appliance is designed for domestic cooking
only. Use for any other purpose could invalidate any
warranty or liability claim.
You will need the following equipment to
complete the cooker installation satisfactorily
STABILITY BRACKET
If the cooker is to be supplied
with gas through a flexible hose,
a stability bracket or chain must
be fitted.
These are not supplied by with the cooker but
are available at most builders' merchants.
GAS PRESSURE TESTER
FLEXIBLE GAS HOSE
Must be in accordance with
the relevant standards.
MULTIMETER
(for electrical checks)
You will also need the following tools:
1. Electric drill
2. Masonry drill bit (only required if fitting the cooker
on a stone or concrete floor)
3. Rawlplugs
(only required if fitting the cooker on a stone or
concrete floor)
4. Steel tape measure
5. Cross head screwdriver
6. Flat head screwdriver
Check the appliance is electrically safe and gas sound when you have finished.
INSTALLATION
7. 4mm & 3mm Allen keys
8. Spirit level
9. Pencil
10. Adjustable spanner
11. Screws for fittingstability bracket
Checking the parts
4 pan supports
Wok Ring
4 flat oven shelves and 1 drop
shelf
Handygrill pan / Meat tin
Plinth Trim
Positioning the Cooker
The diagrams below show the minimum
recommended distance from the cooker to nearby
surfaces.
The cooker should not be placed on a base.
25
Griddle plate
Allen key
Levelling tool
Handygrill rack
Advertisement
Table of Contents
