Ryobi AJP-1600 Owner's Operating Manual
  1. Manuals
  2. Brands
  3. Ryobi Manuals
  4. Pressure Washer
  5. AJP-1600
  6. Owner's operating manual

Ryobi AJP-1600 Owner's Operating Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

AJP-1600
6987304-00 STD( ﾅﾝｱ )
02-16

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AJP-1600 and is the answer not in the manual?

Questions and answers

Yaoyuan Tu
May 16, 2025

What are the specifications of the carbon brushes for the Ryobi AJP-1600?

0

Related Manuals for Ryobi AJP-1600

Summary of Contents for Ryobi AJP-1600

  • Page 1 AJP-1600 6987304-00 STD( ﾅﾝｱ ) 02-16...

  • Page 2: Name Of Parts

    Before starting up your machine please check it carefully for any defects. If you find any, do not start up your machine and contact your distributor. Especially check: The insulation of the electric cable should be faultless and without any cracks. If the electric cable is damaged, it should be replaced by RYOBI authorized distributor.
  • Page 3 • Wear the suitable work clothes. • Check your machine to ensure that it is in good working order. If it is not functioning properly, have it checked by an RYOBI authorized distributor. Have all maintenance and inspection work carried out only by RYOBI authorized distributor.

  • Page 4: Safety Devices

    The motor is equipped with a motor circuit breaker switch. When the motor starts to run hot, it is cut out by this switch. Switch off the machine. Wait 5 ~ 10 minutes before using the device again. Try to determine the cause of the fault. If the problem re- peats itself, please contact RYOBI service centre. Using cleaning agent Fill detergent tank with an appropriate cleaning agent.

  • Page 5: Maintenance And Storage

    • Clean the connectors of dust and sand. • Rinse the detergent spraying attachment after use. Any repair should always be made by RYOBI authorized distributor with original spare parts. Cleaning of lance nozzle A clogging up in the nozzle causes a pump pressure which is too high. This is why cleaning is required immediately.

  • Page 6: Troubleshooting

    Troubleshooting Fault Cause Remedy The pump does not run when the switch The plug is damaged. Check the plug and fuses to see if they is pressed. There is insufficient voltage. are okay. The pump is locked. Manually turn over the motor. The thermal relay has triggered.
  • Page 8 RYOBI tool (hereinafter called “the Product”), for which it was not designed, or is not suited is warranted by Ryobi (herein called “the and no repairs, alterations or modifications Company”) to be free from defects in material...

Table of Contents

Save PDF