Related Manuals for Ryobi AJP-1700V
Summary of Contents for Ryobi AJP-1700V
- Page 1 AJP-1700V, AJP-1700VGQ AJP-1700V AJP-1700VGQ AJP-1700V AJP-1700VGQ 6987306-00 STD( ﾅﾝｱ ) 01-16...
- Page 2 AJP-1700VGQ AJP-1700V AJP-1700VGQ...
- Page 3 凹 凸...
- Page 4 90°...
- Page 5 AJP-1700VGQ ( Attaching the Self Suction Kit ) 20-1 20-2...
- Page 6 D (C)
- Page 7 13, 14 (AJP-1700VGQ)
- Page 8 The insulation of the electric cable should be faultless and 9. Water connector (Main unit attachment) without any cracks. If the electric cable is damaged, it should 10. Hose clamp be replaced by RYOBI authorized distributor. 11. Nozzle cleaning pin 〕 1 2. Water suction filter...
-
Page 9: Safety Devices
Try to determine the cause of • Warning! Spray handle hoses, fittings and couplings are the fault. If the problem repeats itself, please contact RYOBI important components for the safety of the device. Only service centre. use spray handle hoses, fittings and couplings that are recommended by the manufacturer. - Page 10 Changing the Spray Direction (Fig.15) . Attaching the hose joint to the water supply hose The spray handle neck rotates 90 degrees. (Fig.3,,) The spray direction of the variable nozzle lance (6) can be Loosen and remove the hose link from the hose joint (8). changed during operation.
-
Page 11: After Use
Self suction Mode (AJP-1700VGQ) When the trigger is depressed, the motor resumes and pressurized spray is ejected from the nozzle. Attaching the Self suction kit WARNING! 1. Attaching the water suction filter to the water supply port. • Maneuver the spray handle hose carefully over rough •... -
Page 12: Suction Height
Water Pressure” Any repair should always be made by RYOBI authorized • D u r i n g i n i t i a l u s e , t h e s p r a y s t r e a m m a y b e distributor with genuine spare parts. - Page 13 Cleaning the Filters (Fig.32) Storage Pump, hose and accessories should always be emptied of 1. Loosen the water connector (9) and remove it from the water prior to storing as follows: unit. 1. Long periods of nonuse: If the machine is going to be 2. Remove the filter (18) attached to the water connection stored for longer periods of time (i.e.
-
Page 14: Troubleshooting
Troubleshooting Fault Cause Remedy The plug is damaged. Check the plug and fuses to see if they The machine does not run when the There is insufficient voltage. are okay. ON/OFF switch and spray handle lever The pump is locked. Manually turn over the motor. are pressed. - Page 15 Troubleshooting Self suction (AJP-1700VGQ) Fault Cause Remedy Strainer is not completely submerged M a k e s u r e t h a t t h e s t r a i n e r i s (Because the water source decreases completely submerged into the water.
- Page 16 RYOBI tool (hereinafter called “the Product”), for which it was not designed, or is not suited is warranted by Ryobi (herein called “the and no repairs, alterations or modifications Company”) to be free from defects in material...