Page 4
• Warning! Spray handle hoses, fittings and couplings are without any cracks. If the electric cable is damaged, it should important components for the safety of the device. Only be replaced by RYOBI authorized distributor. use spray handle hoses, fittings and couplings that are recommended by the manufacturer.
Try to determine the cause of 4. Connecting the spray handle hose to the spray handle the fault. If the problem repeats itself, please contact RYOBI (Fig.7,8) service centre. Connect the spray handle hose (4) to the spray handle (2) by rotating the hose coupling.
WARNING! Water leakage may occur if the hose is not 6. Operate the spray by depressing the spray handle secured properly or if the connectors are not free from trigger. dirt and debris prior to connecting. The motor stops when the spray handle trigger is released.
Page 7
• Rinse the detergent spraying attachment after use. stored for longer periods of time (i.e. over three months) Any repair should always be made by RYOBI authorized in a room where frost could develop, it is recommended distributor with genuine spare parts.
Troubleshooting Fault Cause Remedy The plug is damaged. Check the plug and fuses to see if they The machine does not run when the There is insufficient voltage. are okay. ON/OFF switch and spray handle lever The pump is locked. Manually turn over the motor.
Page 12
RYOBI tool (hereinafter called “the Product”), for which it was not designed, or is not suited is warranted by Ryobi (herein called “the and no repairs, alterations or modifications Company”) to be free from defects in material...