Opticon OPN2002 Quick Setup Manual page 7

Limited Universal menu book support
In contrary to other Opticon programmable terminals, the OPN2002 also supports
the reading of various configuration options that can be found in the Universal menu
book. This makes it possible to customize this application without having to actually
change the source code of this software.
The OPN2002 support (most of the) menu options listed in the following chapters:
1. Defaults (See chapter 'Supported defaults' at the start of this set-up guide)
2.3. Bluetooth options (See 'Supported Bluetooth features' below)
3.1 Enabling/disabling readable codes
3.2 Setting of fixed, minimum and maximum lengths
3.3 Code specific options (almost all options are supported except some 2D
decoder options)
4.1 Case conversion
4.2 Set prefixes
4.3 Set suffixes
5.1 Add-on wait modes
5.1.1 Multiple read reset time
5.1.2 Quite zone options (margins)
5.4 Redundancy
5.5 Positive and negative barcodes
7.1 Diagnostics
Supported Bluetooth features
In the Opticon Universal menu book there are additional Bluetooth features listed for
Opticon barcode readers with Bluetooth support. Some of these features are also
available on this demo application.
The following of these listed features are supported:
Chapter 2.3.1: Bluetooth connection labels
+-CONN-+
+-DISC-+
+-DSCO-+
Chapter 2.3.3: Configurable Trigger-to-connect time (default = 5 seconds)
Chapter 2.3.4: Configurable Trigger-to-disconnect time (default = 5 seconds)
Chapter 2.3.6: Auto reconnect options (default = 1 minute)
Version history
RFG35310 First release
RFG35311 Added features and bug fixes
Please check our web site at
available for the Operating System, this application and this manual.
(Manually connect label)
(Manually disconnect label)
(Make discoverable / connectable)
www.opticon.com
th
October 10 , 2009
th
October 20 , 2009
to see if there are updates
7