5.4 Installing the protective cover
1
Protective cover DMZ1197-AC
2
Pivot pin
Building Technologies
Fire Safety
If a protective cover (accessories) is used, proceed as follows:
w A compatible protective cover is available. See the chapter 'Accessories
[➙ 23]'.
1. Open the door of the manual call point.
2. Remove the glass insert. See the chapter 'Replacing the glass insert [➙ 35]'.
3. Thread the protective cover (1) through the opening in the door from the front,
as shown in the diagram.
4. Insert the pivot pins (2) for the protective cover (1) in the two recesses on the
rear side of the door, as shown in the diagram.
5. Install the glass insert. See the chapter 'Replacing the glass insert [➙ 35]'.
6. Close the door of the manual call point.
a The protective cover is inserted.
2
1
Figure 12: Installing protective cover DMZ1197-AC on a manual call point FDM223-Ex
Mounting/Installation
Installing the protective cover
A6V10349616_i_en_--
5
31 | 42
2019-01-18