89 North LDI-6 Operating Manual page 27

System Status Indicators
A multi-color System Status indicator ring LED is located on the front panel soft power switch. The System
Status Indicator LED has 3 possible states in normal operation:
•
Yellow, solid:
•
Green, solid:
•
Red, solid:
Other indications are utilized for factory service modes. If the Status Indicator LED displays a color or blink
rate other than described above, contact 89 North. See "Troubleshooting".
Laser Ready Indicators
As shown in Figure 4, the front panel of the LDI includes two Laser Ready Indicators. These indicators
illuminate blue when laser emission through the corresponding aperture can occur. Both Laser Ready
Indicators will remain extinguished while the system is in Warm Up mode since laser emission is prevented
in this mode. Once the system has completed warm up, the Laser Ready Indicator will illuminate blue for
any aperture which is capable of producing laser emission and has a fiber installed.
WARNING:
15000-MNL-01 Rev A
Figure 21: System Reset Button
Indicates the system is in Warm-Up mode
Indicates the system is in Idle or Run mode, ready to be operated and produce
laser emission
Indicates the system is has a fault
Laser Ready Indicators will illuminate blue whenever the corresponding aperture is
capable of producing laser emission.
27