Initial Setup - 89 North LDI-6 Operating Manual

9 Initial Setup

System Components
The LDI-6/7 illumination system is comprised of:
•
Laser light engine
•
External power supply: AC-DC adapter
•
Electrical power cord
•
USB cable
•
External output fibers (89 North supplied or customer supplied)
•
LDI.exe graphical user interface
Carefully unpack all components.
Picking a Location
Place the LDI-6/7 on a flat, level surface, with its feet on the surface in the orientation shown in Figure 2.
Set the external power supply on a flat surface that allows for adequate ventilation on all sides. Maintain
6" (15 cm) of clearance on the front and rear of the LDI. Note that the clearance between The LDI and
other pieces of heat producing equipment should be increased to ensure that the heat from one unit does
not contaminate the required cooling air stream for the other.
NOTE:
NOTE:
Installing Output Fibers and Master Key
Remove the fiber access cover by pressing the fiber access cover release button and lifting the fiber access
cover (Figure 10). Remove the bag containing the master key, USB flash drive, remote interlock mating
connector, and SMA-SMA adapter (if ordered).
15000-MNL-01 Rev A
Maintain at least 6" of clearance around the front and rear or the LDI for adequate
ventilation.
For proper temperature regulation, the LDI must be placed on a flat surface on its
feet.
15