Operation - 89 North LDI-6 Operating Manual

10 Operation

WARNING:
WARNING:
Following initial setup, the LDI is ready to operate. The LDI can be controlled using the graphical user
interface provided (LDI.exe), through serial commands sent to the LDI via USB, or through external analog
and TTL signals to control intensity and shutter positions, respectively. To control the LDI via serial
commands, refer to the LDI End-User Command Specification. The LDI GUI must be used to set control
modes and perform firmware updates.
With the LDI connected via USB to the host PC, launch the LDI GUI (LDI.exe) on the host computer. Prior
to powering the LDI on, the GUI should appear as seen in Figure 15.
15000-MNL-01 Rev A
Caution - use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
Even with protective eyewear, never look directly into the fiber or allow for skin to
be exposed to the beam, as invisible laser radiation can be harmful to the eyes and
skin.
Figure 15. The GUI prior to powering on the LDI.
20