Table of Contents
Advertisement
18/69
Bosch Rexroth AG
Important Notes
1.1.7
Battery Safety
1.2
Appropriate Use
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Rexroth IndraDrive Fc Drive Controllers Frequency Converters FCS01
●
Observe the relevant statutory regulations of accident prevention.
●
Use suitable equipment for mounting and transport.
●
Avoid jamming and crushing by appropriate measures.
●
Always use suitable tools. Use special tools if specified.
●
Use lifting equipment and tools in the correct manner.
●
Use suitable protective equipment (hard hat, safety goggles, safety
shoes, safety gloves, for example).
●
Do not stand under hanging loads.
●
Immediately clean up any spilled liquids from the floor due to the risk of
falling!
Batteries consist of active chemicals in a solid housing. Therefore, improper
handling can cause injury or property damage.
Risk of injury by improper handling!
●
Do not attempt to reactivate low batteries by heating or other methods
(risk of explosion and cauterization).
●
Do not attempt to recharge the batteries as this may cause leakage or
explosion.
●
Do not throw batteries into open flames.
●
Do not dismantle batteries.
●
When replacing the battery/batteries, do not damage the electrical parts
installed in the devices.
●
Only use the battery types specified for the product.
Environmental protection and disposal! The batteries contained in
the product are considered dangerous goods during land, air, and
sea transport (risk of explosion) in the sense of the legal regula‐
tions. Dispose of used batteries separately from other waste. Ob‐
serve the national regulations of your country.
This product may only be used for the applications mentioned in the addition‐
al documentations (see index entry "Additional documentations") and under
the described application, ambient and operating conditions.
This product is exclusively intended for use in machines and systems in an
industrial environment. This is to be understood as applications according to
IEC 60204-1 "Safety of machinery, Electric equipment of machines" and
NFPA 79 "Electrical Standard for Industrial Machinery".
DOK-INDRV*-FCS01******-IT01-EN-P
Advertisement
Table of Contents
