Table of Contents
Advertisement
DOK-INDRV*-FCS01******-IT01-EN-P
Rexroth IndraDrive Fc Drive Controllers Frequency Converters FCS01
1
Important Notes
1.1
Safety Instructions
1.1.1
General Information
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
●
Do not attempt to install and operate the components of the electric
drive and control system without first reading all documentation provided
with the product. Read and understand these safety instructions and all
user documentation prior to working with these components. If you do
not have the user documentation for the components, contact your re‐
sponsible Rexroth sales partner. Ask for these documents to be sent im‐
mediately to the person or persons responsible for the safe operation of
the components.
●
If the supplied documents contain some information you do not under‐
stand, it is absolutely necessary that you ask Rexroth for explanation
before you start working at or with the components.
●
If the component is resold, rented and/or passed on to others in any oth‐
er form, these safety instructions must be delivered with the component
in the official language of the user's country.
●
Only qualified persons may work with components of the electric drive
and control system or within its proximity.
In terms of this Instruction Manual, qualified persons are those persons
who are familiar with the installation, mounting, commissioning and op‐
eration of the components of the electric drive and control system, as
well as with the hazards this implies, and who possess the qualifications
their work requires. To comply with these qualifications, it is necessary,
among other things,
–
to be trained, instructed or authorized to switch electric circuits and
components safely on and off, to ground them and to mark them,
–
to be trained or instructed to maintain and use adequate safety
equipment,
–
to attend a course of instruction in first aid.
●
The technical data, connection and installation conditions of the compo‐
nents are specified in the respective application documentations and
must be followed at all times.
●
If the components take the form of hardware, then they must remain in
their original state, in other words, no structural changes are permitted.
It is not permitted to decompile software components or alter source co‐
des.
●
Do not mount damaged or faulty components or use them in operation.
●
Only use accessories and spare parts approved by Rexroth.
●
Follow the safety regulations and requirements of the country in which
the electric components of the electric drive and control system are op‐
erated.
●
Proper and correct transport, storage, mounting and installation, as well
as care in operation and maintenance, are prerequisites for optimal and
safe operation of the component.
Improper use of these components, failure to follow the safety instructions in
this document or tampering with the product, including disabling of safety de‐
vices, could result in property damage, injury, electric shock or even death.
Bosch Rexroth AG
13/69
Important Notes
Advertisement
Table of Contents
