Name Plate; Transport Safety Instructions; Storage Conditions - ABB VAC D500 Commissioning Instructions

Change from two to one column
1.4.2

Name plate

Fig. 1: Name plate (sample)
1 Full type designation | 2 Order code | 3 Serial number
6 Date of manufacture | 7 Explosion protection | 8 Manufacturer | 9 Supply pressure | 10 Input signal | 11 Ambient temperature range |
12 Output | 13 Safety function (no current) | 14 Communication protocol | 15 Degree of protection | 16 Options
Change from one to two columns
1.5

Transport safety instructions

Observe the following instructions:
— Do not expose the device to moisture during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
| D500
6 CI/EDP300-EN Rev. A
| 4 Special version | 5 Hardware revision / Software revision |
1.6

Storage conditions

— The device must be stored in dry and dust-free conditions.
The device is also protected by a desiccant in the
packaging.
— The desiccant guarantees sufficient protection for
approximately 150 days. It can be regenerated at a
temperature of 90 °C (114 °F) within 4 h.
— Remove the desiccant prior to commissioning the actuator
or the electronics.
— If you intend to store or transport the device for a prolonged
period (> 6 months), we recommend that you wrap it in
plastic film and add desiccant.
— Observe the permissible storage and transport
temperatures.
— Protect uncovered metallic surfaces with an appropriate
long-term corrosion inhibitor.
— Observe the relevant long-term storage temperatures.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.