Electrical Connections; Connection Diagram - ABB VAC D500 Commissioning Instructions

Change from two to one column
4

Electrical connections

IMPORTANT (NOTE)
The cable terminals are delivered closed and must
be unscrewed before inserting the cable.
1. Strip the wire by approx. 6 mm (0.24 inch).
2. To connect the signal lines, the emergency shutdown module, and the proximity switches or microswitches, insert the wire
ends from the left into the respective screw terminals and tighten the screws so that they are hand-tight (access from
above). To connect a plug-in module, insert the wire ends from above into the appropriate screw terminals and tighten the
screws so that they are hand-tight (access from the side).
4.1

Connection diagram

Fig. 16
A Basic device | B Options
1 Analog input | 2 Digital input | 3 Digital output | 4 Binary feedback | 5 Analog feedback | 6 Proximity switches |
7 Microswitch | 8 Emergency shutdown module | 9 Universal input
IMPORTANT (NOTE)
Keep cable shields as short as possible and
connect on both sides.
D500
| CI/EDP300-EN Rev. A 15