Safety; General Information And Notes For The Reader; Intended Use; Target Groups And Qualifications - ABB VAC D500 Commissioning Instructions

1

Safety

hange from one to two columns
1.1

General information and notes for the reader

You must read these instructions carefully prior to installing
and commissioning the device.
These instructions are an important part of the product and
must be kept for future reference.
These instructions are intended as an overview and do not
contain detailed information on all designs for this product or
every possible aspect of installation, operation and
maintenance.
For additional information or if specific problems occur that are
not discussed in these instructions, contact the manufacturer.
The content of these instructions is neither part of any
previous or existing agreement, promise or legal relationship
nor is it intended to change the same.
This product is built based on state-of-the-art technology and
is operationally safe. It has been tested and left the factory in
perfect working order from a safety perspective. The
information in the manual must be observed and followed in
order to maintain this state throughout the period of operation.
Modifications and repairs to the product may only be
performed if expressly permitted by these instructions.
Only by observing all of the safety instructions and all
safety / warning symbols in these instructions can optimum
protection of both personnel and the environment, as well as
safe and fault-free operation of the device, be ensured.
Information and symbols directly on the product must be
observed. They may not be removed and must be fully legible
at all times.
|D500
4 CI/EDP300-EN Rev. A
1.2

Intended use

Positioning of pneumatically controlled actuators; designed for
mounting on linear and part-turn actuators.
The device is designed for use exclusively within the stated
values on the name plate and in the specifications (see the
"Specifications" section on the data sheet).
— The maximum operating temperature must not be
exceeded.
— The permissible ambient temperature must not be
exceeded.
— The housing protection type must be observed.
1.3

Target groups and qualifications

Installation, commissioning and maintenance of the product
may only be performed by trained specialist personnel who
have been authorized by the plant operator to do so. The
specialist personnel must have read and understood the
manual and comply with its instructions.
The operators must strictly observe the applicable national
regulations with regards to installation, function tests, repairs,
and maintenance of electrical products.