Mounting The Hood - DeDietrich DHD7000X Manual To Installation

UTILISATION
This product is intended to extract fumes, fats, and steam from cooking. It has been designed
and made for use either in the suction or filter versions.
VERSION EVACUATION exterieure
The hood is equipped with an air outlet (Fig. A FIGURE 5) to convey smoke outwards (the flue
pipe and fixing flange are not supplied).
Check valve blockage
Warning: Before connecting the air exhaust hose, make sure that the check valves are free to
turn over freely.
In filtering application that the stop valve doesn't permit the entrance of wind and exhau-
sted air.
Filtering version
In the case an exhausting hole is not possible, the hood can be used in filtering version. For this
mode charcol filters are to be fitted inside the hood. Filtered air will be evacuated in the kitchen
trough a duct that conveys the air on a side of the cabinet (picture 6 bis).
ELECTRIAL HOOK UP
This appliance conforms to the European Directives 2006/95/EC (Low Voltage Directive)
and 2004/108/EC (Electromagnetic Compatibility).
When you install the appliance and carry out maintenance, it must be unplugged from the power
source or the fuses must be disengaged or removed. Electrical hook up must be carried out
before the appliance is installed in the cabinet.
Check that:
- the power source is sufficient,
- power cords are in good condition,
- The diameter of the cables conforms to installation regulations.

- MOUNTING THE HOOD

Installation must conform to the regulations in force regarding the ventilation of
enclosed environments. In France, these regulations are container in the DTU 61.1 of the
CSTB. In particular, discharged air must not be channelled into a conduit used for exhaust
discharge or discharge from devices that operate with gas or other combustible materials.
The use of unused conduits is not permissible without the approval of a qualified techni-
cian.
32