Makita DUR142L Instruction Manual page 15

WARNING:
• Be extremely careful to maintain control of
the tool at all times. Do not allow the tool to
be deflected toward you or anyone in the
work vicinity. Failure to keep control of the tool
could result in serious injury to the bystander
and the operator.
Adjustment of the hanger position
and shoulder harness
► Fig.27: 1. Hex bolt
To change the hanger position, loosen the hex bolt on
the hanger with the supplied wrench. Then move the
hanger.
After adjusting the hanger position, tighten the hex bolt
with the wrench securely.
MAINTENANCE
WARNING:
• Always be sure that the tool is switched
off and battery cartridge is removed before
attempting to perform inspection or main-
tenance on the tool. Failure to switch off and
remove the battery cartridge may result in seri-
ous personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
► Fig.28
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
► Fig.29: 1. 80-100 mm
Cut a nylon line in 3-6 m. Fold the cutting line in two
halves, leave one of half longer 80-100 mm than
another.
► Fig.30
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 chan-
nels provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for left hand direction indicated by
LH.
► Fig.31
Wind all but about 100 mm of the cords, leaving the
ends temporarily hooked through a notch on the side of
the spool.
► Fig.32
Mount the spool on the cover so that the grooves and
protrusions on the spool match up with those on the
cover. Now, unhook the ends of the cord from their tem-
porary position and feed the cords through the eyelets
to come out of the cover.
► Fig.33
Align the protrusion on the underside of the cover with
the slots of the eyelets. Then push the cover firmly onto
the housing to secure it. Make sure the latches fully
spread in the cover.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
15 ENGLISH