Carrier 19DV Series Installation, Operation And Maintenance Instructions page 35

Notes :
1. Each chain must be capable of supporting the entire weight of the machine. See chart for maximum
weight. (The maximum weights shown cover weights from steel and copper tubing, insulation, and
refrigerant charge, excluding water weight.)
2. Chain lengths shown are typical for 4.5 m lifting height. Some minor adjustments may be required.
Dimensions A and B define distance from machine center of gravity to tubesheet outermost surfaces. Dim
"C" defines distance from machine c.o.g. to floor. Dim "D" defines distance measured between the chain and
lifting hooks.
3. Rigging can be different and specific if unit is equipped of special components or devices which
could have interference with chain way. Please refer always to the official dimensional drawings of
the ordered job and contact customer service to get more information for rigging.
IMPORTANT : Make sure that rigging cable is over the rigging bar before lifting.
Fig 16 – Machine Rigging Guide (comp frame size DV4)
35