Linhai LH50DU Owner's/Operator's Manual page 82

11. BATTERY
5. Always use a extension cord with a minimum rating of 20 amps.
6. Inspect the charging cord and extension cord for cracks, loose
connections and frayed wiring. Replace any damaged components
promptly.
7. Always connect the extension cord to the charge receptacle on the
vehicle first, then plug the cord into a wall receptacle.
8. Make sure the charger uses a dedicated circuit to prevent
overloading. If charging multiple vehicles, each vehicle should use a
dedicated circuit.
Tip: After the batteries have fully recharged, the battery charger will
automatically cycle in and out of the trickle charge mode to maintain the
charge.
9. When disconnecting the charger, always disconnect the extension
cord from the wall receptacle first, then disconnect the cord from the
vehicle's charge receptacle.
Battery Inspections
Inspect battery terminal connections monthly. Clean batteries as
recommended. Using an insulated wrench, torque bolts to 8 ft. lbs. (11
Nm). If your vehicle is equipped with sealed batteries, no other
maintenance is required.
Battery Access
To access the batteries, remove the seat. Remove the storage tray (if
equipped).
NOTICE: Before removing the seat to access the batteries, make sure
any wire or metal items (including seat belt latches, if equipped) remain
clear of the battery compartment to avoid causing a short circuit to the
electrical system.
OWNER'S/OPERATOR'S MANUAL
LH50DU 1.0
11-6