Table of Contents
Advertisement
Category
Function
Voice
Pitch Bend*
Modulation (+), (-)*
Modulation (+), (-)
Alt
Modulation Hold
On/Off
Initial Touch On/
Off
Left Hold On/Off
Pedal Control
(Wah)
Organ Rotary Slow/
Fast
Kbd Harmony/
Arpeggio On/Off
Arpeggio Hold
Registration
Registration
Memory
Registration
Memory1–8
Registration
Sequence +/-
Registration Bank
+/-
Registration Freeze
On/Off
Registration
Sequence On/Off
Live
Live Control Assign
Control
Live Control Reset
Value
Chord
Chord Looper On/
Looper
Off (PSR-SX900)
Chord Looper Rec/
Stop (PSR-SX900)
Functions
Description
Allows you to bend the pitch of notes up or down by using the pedal. You
can make the following settings at the bottom of this display.
• Up/Down: Determines whether the pitch change goes up (is raised) or
down (is lowered).
• Range: Determines the range of the pitch change, in semitones.
Applies vibrato and other effects to notes played on the keyboard.
This is a slight variation on Modulation above, in which the effects (wave-
form) can be alternately turned on/off by each press of the pedal/foot-
switch.
Same as the [MODULATION HOLD] button.
Turns the Initial Touch setting of each keyboard part on the Keyboard/Joy-
stick display on/off.
Same as the [LEFT HOLD] button.
Applies a wah effect to notes played on the keyboard. You can turn this
function on or off for each keyboard part at the bottom of this display.
NOTE
The effect can be applied only to specific Voices.
Switches the Rotary Speaker speed
Same as the [HARMONY/ARPEGGIO] button.
While the pedal is pressed (hold on), Arpeggio playback continues even
after you release the keyboard, and then Arpeggio stops when the pedal is
released (hold off). When this function is assigned to the button, each press
of the button alternately toggles between hold on and hold off.
Make sure that any one of the Arpeggio type is selected and the [HAR-
MONY/ARPEGGIO] button is turned on.
Same as the REGISTRATION MEMORY [MEMORY] button.
Same as the REGISTRATION MEMORY [1]–[8] buttons.
Advances/reverses through the Registration Sequence.
NOTE
If you want to use a pedal, set the "Pedal Control" on the Registration Sequence display
(page
87).
Same as the REGIST BANK [+]/[-] buttons.
Same as [On]/[Off] on the Registration Freeze display
Same as [On]/[Off] on the Registration Sequence display
Same as the LIVE CONTROL [ASSIGN] button.
Same as [Reset Value] on the Live Control display
values of all the assignable functions of Live Control.
Same as the CHORD LOOPER [ON/OFF] button.
Same as the CHORD LOOPER [REC/STOP] button.
(page
50) between "Slow" and "Fast."
(page
86).
(page
87).
(page
117). Resets the
PSR-SX900/SX700 Reference Manual
Assignability
P
A
R
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
10
-
-
-
-
-
-
-
113
Advertisement
Chapters
Table of Contents
